Preparation

Before installing the glass, remove any protective film or screen protectors on the device and make sure that your smartphone display is thoroughly cleaned with the cleaning solution provided. Next place the KMP Dust Removal Sticker (sticker is in the bag together with the glass) on top of the display, so that dust and dirt can no longer settle on the display (please leave the sticker on the display during installation).

Make sure that the vent screw is closed. (Close by turning clock wise so the lines are aligned)

Distance plate

On some of the iPhone models the addition of a distance plate is required.
Make sure that the distance plate, if necessary, is inserted.

1. Insert the smartphone

Open the lid of the machine. Slide the upper grab all the way up (hold position) and insert the smartphone as shown. Now slowly release the upper grab so that the smartphone is automatically positioned.

TIP: Press the gripper with the thumb of your left hand and hold it with your index/ middle finger from behind. Sudden release of the gripper can cause damage to the smartphone.

2. Insert glass

Now take the smart glass out of the bag. Place the glass flat on the display, using the indents on glass and the recesses on the side holders of the machine so it lies flat. Important: You must be able to read the writing on the glass/backsheet! Close the lid slowly.

3. Suck in the glass

Press the vacuum knob once until it stops and release it slowly. Now open the lid. The glass should now be stuck to the reverse of the lid.

TIP: For optimal suction, only about 2mm of the knob should be visible when the vacuum knob is pressed. A light pressure on the lid helps to ensure airtight suction of the glass.

4. Pull off Backsheet

To remove the backsheet, use your left hand to stabilize the lid of the machine. With your right hand (thumb and forefinger), slowly and carefully pull off the backsheet from the top centre.

TIP: Jerky or asymmetrical removal of the backsheet can shift the glass and lead to an inclined mounting. Once the backsheet is removed, you should work quickly to avoid dust.

5. Mounting the glass
!(Please read the instruction completely before you start with the execution. Afterwards, please make sure that the following steps are carried out as quickly as possible to avoid the formation of large bubbles)!

Close the lid with your right hand and at the same time pull the dustremoval sticker on the tab towards you with your left hand. As soon as the lid is closed, turn the vent screw anti clockwise to release the suction. (A quarter turn of the wheel is sufficient). Leave the screw open and open the cover again.

TIP: To minimise the risk of dust, remove the Dustremoval sticker just before the glass rests on the display.

6. Fine tuning

Now wait until the protective glass is completely connected to the display and tightened. Any air inclusions can be smoothed out gently towards the edge using the microfibre cloth provided or corrected by partially lifting the glass.